ITW Dynatec DY 2008 - Pressure Curve Configuration

RETURN
ACCESS CODE: ----
STOP
1: 0 m/min
123
RETURN
STOP
CONTRAST+
CONTRAST-
RETURN
1: 0 m/min
TRIGGER SETUP
PRESSURE SIGNALING
PRESSURE ASSIGNMENT
PRESSURE CURVE
SPIKE VOLTAGE
SPIKE DURATION
SHUTTER ASSIGNMENT
SHUTTER DWELL TIME
CHANGE SECURITY LOCK
1
2
3
4
5
6
7
8
9
Code
--
--
--
--
--
--
--
--
SERVICE SETTINGS 2 OF 3
123
2: 0 m/min
3: 0 m/min
4: 0 m/min
Page 4-- 26
Manual #50-14 Revised 8/08
C. 1998
Pressure Curve Configuration
Use this menu to select either 2 or 12-point pressure
curves.
Press button 4.
Enter Access Code if this function is
protected.
Press Enter Button.
Press F1 or F2 to select a pressure output.
Use button F3 to toggle between 2-- point
and 12point pressure curve
Confirm the selection with t he Enter button
and repeat the procedure for the next
pressure output.
Press F4 to return to previous menu.
STOP1: 0 m/min
2: 0 m/min
3: 0 m/min
PRESSURE CURVE MENU
2 POINT / 12 POINT
OUTPUT
1
2
3
4
4: 0 m/min
RETURN
2 POINT
2 POINT
2 POINT
2 POINT
1
1
STOP1: 0 m/min
2: 0 m/min
3: 0 m/min
PRESSURE CURVE MENU
2 POINT / 12 POINT
System
1
2
3
4
4: 0 m/min
RETURN
12-POINT
2 POINT
2 POINT
2 POINT