ITW Dynatec DY 2008 - Pressure Adjustment

C1:
C2:
C3:
C4:
C5:
C6:
C7:
C8:
PATTERN
PRESSURE
SYSTEM COMP.
1: 0 m/min
PRESS1: 0%
PRESS2: 0%
PRESS3: 0%
PRESS4: 0% PROGRAM.:
1
2: 0 m/min
3: 0 m/min
4: 0 m/min
PRESSUREPRESSURE
OUTPUT
1
RETURN
MIN. PRESSURE
MAX. PRESSURE
PURGE PRESSURE
PRESSURE SETTINGS OUTPUT 1
10%
100%
70%
1: 0 m/min
2: 0 m/min
OUTPUT
3: 0 m/min
4: 0 m/min
RETURN
MIN PRESSURE
MAX PRESSURE
PURGE PRESSURE
PRESSURE SETTINGS OUTPUT 1
10%
90%
70%
OUTPUT
1: 0 m/min
2: 0 m/min
3: 0 m/min
4: 0 m/min
9
Manual #50-14 Revised 8/08
Page 4-- 45
C. 1998
Pressure Adjustment
The shown display appears a few seconds after
switching on the pattern controller. If you are in a
different menu, press F4 RETURN as many times as
necessary to return to the Main Menu, as shown at
right.
Press button F2.
Use button F3 to select a Pressure Output.
Note! Depending on whether a 2--Point or
12--Point Pressure Curve is selected for
the particular pressure output (X24 thru
27) (Service Setting Menu 2 of 3, Function
4) different settings are necessary.
Minimum Pressure Adju stment (2-Point Curve)
Use the numeric keys to enter the minimum
pressure at zero machine speed, e.g. 10%.
Maximum Pressure Adjustment (2-Point Curve)
Press button F1 or F2 to select the pressure
at maximum machine speed.
Use the numeric keys to enter the pressure
for maximum machine speed e.g. 90%.