C1:
C2:
C3:
C4:
C5:
C6:
C7:
C8:
PATTERN
PRESSURE
SYSTEM COMP.
1: 0 m/min
PRESS1: 0%
PRESS2: 0%
PRESS3: 0%
PRESS4: 0% PROGRAM.:
1
2: 0 m/min
3: 0 m/min
4: 0 m/min
SYSTEM
RETURN
STITCH OFFSET
1: 0 m/min
2: 0 m/min
3: 0 m/min
4: 0 m/min
C1:
C2:
C3:
C4:
C5:
C6:
C7:
C8:
SYSTEM MENU
DOTS
DOTS
Page 4-- 48
Manual #50-14 Revised 8/08
C. 1998
System Menus: Dot Configuration, Stitching and Head Position
The shown display appears a few seconds after
switching on the pattern controller. If you are in a
different menu, press F4 RETURN as many times as
necessary to return to the Main Menu, as shown at
right.
Press button F3.
Use this menu to adjust the Dot-Configuration,
Stitching and Head Position (Offset) parameters.
Dot Configuration
The ability to enter the Dot Configuration Menu is
offered when one of the “ dot modes” (i.e. STANDARD
WITH DOT or DOT) have been selected in the Service
Settings Menu 1 of 3, Function 8.
Press button F1 from the SYSTEM MENU.
Only those channels with modes
programmed for dots (see above) will be
displayed.
Use the F1 or F2 buttons to select a channel.
Press the F3 button to highlight the REPEAT
value. The REPEAT is the distance in
millimeters (inches) that the product must
travel before the next dot will be applied.
CHAN. 3
1: 0 m/min
STOP
ZURUECK
DOT CONFIGURATION REPEAT (mm) GLUE (ms)
RETURN
1
10
1.00
4.50
CHAN. 2
CHAN. 2
CHAN. 3
1: 0 m/min
STOP
ZURUECK
DOT CONFIGURATION REPEAT (mm) GLUE (ms)
RETURN
1
10
1.00
4.50
5
+1mm -1mm
123
To Next Page
Loading...