Barcode Scanning XT2 User Manual
Janam Technologies LLC Version 3, April 2017 Barcode Scanning 9—2
Scan Settings
Go to Tools > Scan Set-
tings to configure the XT2’s
scan engine and software.
This is where you set how
the scanner will work, how
it will announce and commu-
nicate results, what all the
scan operation settings
should be and, most impor-
tantly, which of the numer-
ous code symbologies the
scanner should read.
Tab Section Option Description
Basic Scanning Trigger timeout (sec) Specifies the trigger time out in seconds. If a
barcode is not decoded within the specified
timeout, the default Notifier indicates that
decoding is failed.
Enable Auto Scan Enable Auto Scan with specified interval.
Auto Scan interval Set Auto Scan interval time.
Enable Cont. Scan Enable Continuous Scan without any interval.
Wedge mode Result Type Select Result Type :
Keyboard Event
Clipboard(default)
Terminator Select the desired barcode end method from the
pull down list.
Values: None, Tab, Space, LF
Notification Beep Enable Beep Set enable/disable plays audio sound.
Good read Set sound to indicate good read.
Bad read Set sound to indicate bad read.
LED Enable LED Set enable/disable visual scan indicators.
Vibrator Enable Vibrator Set enable/disable vibrator operation.
Good read Set vibration time after good read.
Bad read Set vibration time after bad read.
Wedge Barcode ID Transmit Barcode ID Enable to transmit predefined barcode ID in
Detail tab
Label Prefix Enter Prefix to be sent prior to the
decoded/received data.
Suffix Enter Suffix to be sent after the
decoded/received data
Symbologies Select barcode types you want to read
There is “Enable All” and “Disable All” to enable/disable all symbologies
About Specifies Barcode engine type, Firmware revision, Decider revision, API revision
Factory Default Load Factory Default After modifying the current settings, if you wish
to return to the factory defaults, tap the Load
Factory Default button.
To Next Page
Loading...
