Jandy TruClear User Manual

Page 26
ENGLISH
Jandy
®
Pro Series TruClear
™
Chlorine Generating System
|
Installation & Operation Manual
Section 8. Display Readings
8.1 Display Reasons and Descriptions
Display Reading Reason Description
EN Language on startup This is the acronym which should appear
during the 3 seconds startup screen.
English Language Language selected/available for the user.
Output is OFF while selection is made.
Standby Standby When the system is ready and waiting for
the next valid chlorination cycle without any
errors. Output is OFF.
Chlorinating Chlorination When the system is operating within a valid
chlorination cycle without any errors. Output
is ON.
Cleaning Polarity is reversing When the system is operating within valid
chlorination cycle and the duty cycle timer
has expired. Output is OFF.
Lo Temp/Lo Salt Low water conductivity When the system detects low water
conductivity, this could be caused by cold
water, low salt levels, or a combination of the
two. Check the salt level. Output is ON.
No Flow Nooworlowow Whenthesystemdetectsanabsenceofow
while operating within a valid chlorination
cycle. Output is OFF.
Check Cell Cell overload When the system is running within a valid
chlorination window and detects a cell short
circuit or overload. Designed to warn the
user or service person. Output is OFF.
Check Cell Cell open circuit
When the system is running within a valid
chlorination window and detects a cell open circuit
or disconnection. Designed to warn the user or
service person. Output is off but retries each 30
seconds.
Over Temp Overheated controller
The controller detects internal temperature and
may can reduce output power as a self-protection
feature.
At 70ºC (internal) output power to the cell is
reduced by 50% (no message displayed).
At 80º C (internal) output power to the cell is
reduced to 0% (OFF), and this over temperature
error is displayed. Output is OFF.
Designed to warn the user or service person of
overheating.
Pleaseconrmthatthiswarningmessage
automatically disappears when internal temp goes
below 80 °C.

Jandy TruClear Specifications

General

Type	Saltwater Chlorinator
Cell Material	Titanium
Pool Size Capacity	Up to 40, 000 gallons
Control Interface	Digital
Power Supply	120/240 VAC
Installation	Inline plumbing installation
Salinity Range	2500 - 4500 ppm
Plumbing Size	2 inch