Jasco CD-1595 - Changing GAIN

4-5
4.2.2
Changing GAIN
The GAIN changes the gain of the CD signal amplifier. Normally, GAIN
should be set to “X10”. In case a sample compound gives so strong CD
signal that may saturate the amplifier and “CD Sig.: 3.9000 V” is
displayed(see Fig.5.2) , the setting “X1” should be used to reduce the CD
signal to a proper level.
GAIN: X1 or X10
[EDIT/ENTER]
Normal Operation Mode Display
Select x10 or x1
[ ][ ]
▲▼
Blinking
NORM291X10
0.0000.000STD
NORM291X10
0.0000.000STD
[EDIT/ENTER]
Setting GAIN
[EDIT/ENTER]
[EDIT/ENTER]
NORM291X1
0.0000.000STD
Figure 4.4 Changing GAIN
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com