Jasco CD-1595 - Preparation for Measurement and Basic Operation; Preparation for Measurement

4-1
FromINJECTOR
MARKOUT
ToPUMP
STOPIN

ToINTEGRATOR
STARTIN
LEAK
IN
CELL
MARK
OUT2
MARK
OUT1
LAMP
OFF
TROUBLE
OUT
MARK
IN
A/Z
IN
PRGM
RST
/ST
AUZ
4. PREPARATION FOR MEASUREMENT AND BASIC
OPERATION
This chapter describes the basic operation procedures necessary for a simple
measurement.
4.1 Preparation for Measurement
1) Connect a strip chart recorder and or an integrator (or a data processing
system) to the instrument referring to Chapter 2 “Names and Functions of
Parts”.
Figure 4.1 Connection of input/output terminals on the rear panel and the
other instruments.
2) Connect column outlet tubing to the inlet port of the CD-1595 flow cell.
Use 1/16 in. OD x 0.25 mm I.D. tube and 1/16 in. fittings.
AU
1V/AU
CD
1V/deg
CD
10mVF/S
AU
10mVF/S
To Chart recorder
Input terminals 10mV
To Integrator
Input terminals
To Integrator
Input terminals
To Chart recorder
Input terminals 10mV
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com