Jasic EVOLVE 200 - 2.7.2.3 2 T;4 T Setting; 2.7.2.4 SETTING Menu

EVOLVE 200 USER MANUAL
23
Press the PROG button twice to enter in the tungsten diameter
selection menu. Select the diameter by KNOB1 and confirm by
pushing the KNOB1.
2.7.2.3 2T/4T Setting
Push the 2T/4T button to enter in the 2T/4T menu.
Select the 2T/4T by KNOB1 and confirm by pushing the
KNOB1.
It is possible to select 2 Time, 4 Time, SP (SPOT).
2.7.2.4 SETTING menu
SETTING MENU
Push the SETTING button to enter in the setting menu.
SELECT the sub menu by knob1 and confirm by pushing the
knob1.
- Technical Parameter (See Table 2.2)
- JOB menu: select the job
- MACHINE INFO: can show the machine SN and more
information.
- RESTORE FACTORY: restore default settings of the working data in the selected welding section.