18
3. Designated use and function
3.2 Designated use
3.2.1 Operation purpose
The Jensen woodchippers are designed as a movable machine for chipping brush and
trunk wood of variable length. The max. trunk diameter can be found in the technical
data.
Examples for allowed materials:
allowed:
Brush wood
Trunk wood up to the max. diameter
unallowable:
metal or scrap
rubble, concrete, rocks etc.
intense winding materials e.g. carpet, plastic fiber etc.
Every material that is not mentioned under the headword allowed (see above).
In case of ambiguity contact the manufacture.
Note
The definition above (operation purpose) specifies the designated use of the
woodchipper. Every use that differs from this or from the order designations deems to
be a not designated use. The operator is in charge for persons and the machine in
case of misuse. For cases of misuse all rights of warranty and guarantee expire.
3.2.2 Site of operation
It is only allowed to set up the woodchipper on a flat and stable ground and outside of
closed buildings. The machine must be set up in a way so that the operator has
sufficient operating range and that there are no dangers for the operator from site
during operation (stumble, slip, getting stuck etc.). The operation site must be secure
so that the safety devices of the machine do not get affected.
To Next Page
Loading...
