37
5. Operation and maintenance devices
switches off completely and the engine must be restarted. The process for changing
the time delay is described in the following section.
The ECO Mode is always displayed in the HCflex, even if the option
has not been installed in the machine at all. In this case, the ECO
Mode is without function.
5.7.1.3.3 Configure Eco Mode:
The Eco mode (1) is set via the following menu:
To change the time delay for Eco
mode, use [↑] [↓]. In order for the
time to be set, the menu must be
confirmed in advance with the [1]
key. After the desired time has been
switched on, the [3] key can be used
to exit the menu again.
5.7.1.3.4 Configure exhaust gas aftertreatment:
The exhaust gas aftertreatment of modern diesel engines makes it necessary to
integrate regeneration phases into operation. The regeneration phases are required
at regular intervals so that the accumulated particles can be burned off in the filter and
a smooth operation of the engine can be ensured.
Please note that exhaust gas temperatures of up to 600°C are
reached during regeneration. Only regenerate if the working
environment is suitable for appropriate exhaust gas temperatures.
Figure 3- Configuring Eco Mode
To Next Page
Loading...
