JetCat P550-PRO - High Power Hazard Zones

70 pages

Save Page as PDF

To Next Page

To Previous Page

Ingenieurbüro CAT, M. Zipperer GmbH +49-7634-5056-800

Wettelbrunner Straße 6 sales@jetcat.de

10 79282 Ballrechten-Dottingen www.jetcat.de

GERMANY

Instruction

anual JetCat

PRO engines

1.7

V12.01V

Hazard areas on engine idle +20% to full power operation

Main Page

Default Chapter2
- Table of Contents2
Introduction4
Features5
Safety, Meaning of Symbols7
Safety Precautions7
- Hazard Areas9
  - Hazard Areas on Engine Startup and Idle Operation9
  - Hazard Areas on Engine Idle +20% to Full Power Operation10
Mounting / Fixing of the Engine11
Connections on the Engine, Overview12
- Data Connector (A)13
- Power Connector (B)15
- Power Supply15
- Expansion Connector (C)16
- Fuel Connector Port17
  - Fuel17
  - Fuel Connection Diagram, Standard17
- Bleed Air Port (Optional) ; Pressurization of Fuel Tank18
  - Fuel Connection Diagram, Pressurized Fuel Tank18
Jetcat Pro-Interface19
- Connection Overview, PRO-Interface20
- System Connection Diagram with Pro-Interface23
  - Connection Diagram A); Direct Battery Connection23
  - Connection Diagram B); Battery Connection Via PRO-Interface24
Ground Support Unit (Gsu)25
- Connection of Gsu25
  - A) GSU Connects to Engine Sided 4-Pin Molex Connector25
  - B) GSU Connects to the Jetcat PRO-Interface25
- Gsu Control Panel Descriptions26
  - GSU Button Descriptions27
  - Description of Leds on the GSU27
Operation Modes28
- Industrial Operation Mode, Normal Altitude28
- Ndustrial Operation Mode Igh Altitude Without Altitude Controlled Low Rpm Governing28
- Ndustrial Operation Mode Igh Altitude with Altitude Controlled Low Rpm Governing28
- Operation Mode for Propulsion of RC-Models28
- Setup/Adjustment of the Operation Mode28
Engine Power On/Off29
- Power on Via RC-Signal from Receiver29
Engine Control30
- Control Options30
- Control Via Serial Bus (Com1)39
- Control Via Can-Bus39
Preparing Fuel and Fuel System39
- Prime the Pump and System40
Running the Engine for the First Time41
- Initial Adjustments41
- The Checklist41
Gsu (Run Menu Default) Display Symbols43
- Initial Default Display Screen after Power up43
- Fter Power up Error Condition Display Screen43
- Engine Starting Display Screen44
- Engine Running Display Screen44
Engine Running States45
- Explanation of the Engine States45
Troubleshooting48
- Most Frequent Errors48
  - Ost Frequent Errors Ause and Remedy48
- Reason for an Unexpected Shut-Down49
Manual Advanced Section50
- Smoker Pump50
Menu Structure51
- Menu Selections51
  - Selecting a Menu51
  - Change Values / Items51
- The Run Menu52
- The Min/Max Menu52
- The R/C Check Menu53
- The Info Menu54
- The Statistic-Menu55
- The Limits Menu56
Special Functions64
- Temperature Calibration64
- Reset to Default Values65
Firmware Update66
Jetcat Three Year Limited Warranty69

JetCat P550-PRO - High Power Hazard Zones

Table of Contents

Related product manuals