M
Ingenieurbüro CAT, M. Zipperer GmbH +49-7634-5056-800
Wettelbrunner Straße 6 sales@jetcat.de
39
79282 Ballrechten-Dottingen www.jetcat.de
GERMANY
Control via serial Bus (COM1)
Please refer to our separate available documentation on the serial control interface.
Control via CAN-Bus
Please refer to our separate available documentation on the CAN-bus protocol.
Preparing fuel and fuel system
Warning!
Obey local laws for the transportation and storage of fuels.
Fire warning!
When mixing the fuel with oil or when operating (fueling, defueling, etc.), never handle near an
open flame.
Please do not spill or empty fuel to the ground.
The JetCat engine can use deodorized kerosene, 1-K kerosene or Jet-A1 for fuel. Fuel must be mixed with 3-5%
synthetic engine oil.
Example formula: 1 quart of oil in 5 gallons of fuel.
JetCat recommends low toxicity JetCat oil with anti-static additive or Aeroshell 500 engine oil although any engine oil
that conforms to MS23699 standards will work.
To reduce static charges from the fuel system, we recommend adding our anti-static additive (Part# 61198-00) or
JetCat Turbine Oil (Part# 61197-00) with anti-static additive already blended in.
Please note: Fully synthetic 2-stroke oils or Mobil DTE are not suitable and must not be used.
To Next Page
Loading...
