JetCat P550-PRO - Reset to Default Values

M
Ingenieurbüro CAT, M. Zipperer GmbH +49-7634-5056-800
Wettelbrunner Straße 6 sales@jetcat.de
65 79282 Ballrechten-Dottingen www.jetcat.de
GERMANY
Instruction
m
anual JetCat
-
PRO engines
,
1.7
-
V12.01V
Reset to Default Values
The ECU can be reset to default values by following:
Press and hold the „Select Menu“ key on the GSU, then switch on the ECU (receiver).
The LED’s indicate the following blink sequence:
LED Blink Sequence
Standby       (yellow)
Pump running            (red)
OK       (green)
The display of GSU indicate simultaneously: Release Key to „Learn RC“
While this sequence keep „SelectMenu“ button pressed, don’t release it !!!!
After a while (approx. 15 seconds) the LED’s indicates the following blink sequence:
LED Blink Sequence
Standby       (yellow)
Pump running            (red)
OK       (green)
While this sequence hold the key „SelectMenu“don’t release it !!!!
Release the key not before the LED’s indicate following sequence:
LED Blink Sequence
Standby       (yellow)
Pump running            (red)
OK       (green)
Simultaneously the display of GSU indicates: “Release key to Reset System”
Now release the key to execute the reset.
After a reset, it is required to:
 Learn in RC