John Bean ALIGNMENT 44218Q - CONTENTS

11 of 76
 TAPE MEASURE
 ELECTRICAL TAPE
 STEP LADDER (adjusting cables and/or safety ladder in posts)
 SIDE CUTTERS (for cutting shipping straps)
 (8) JACK STANDS (set up)
 STANDARD SOCKETS AND WRENCHES
 ALLAN KEY SET
 SCREWDRIVER SET
 FLOOR JACK OR ENGINE HOIST
 BOX CUTTER / SNIPS (to remove packaging)
 RUBBER OR PLASTIC MALLET
5.0 CONTENTS
The lift is packaged to protect it from any damage that may occur during shipping. The
two deck assemblies and crossmembers are packaged together with the accessory
boxes strapped to them.
Main Structural Components:
1 - Left Side Deck Assembly (complete with hydraulic cylinder, sheaves and cables)
1 - Right Side Deck Assembly
1 - Front Crossmember Assembly (with air cylinder release locks and sheaves)
1 - Rear Crossmember Assembly (with air cylinder release locks and sheaves)
Accessory Box Components
Box 1 Contents:
1 - Power Post (with safety ladder)
3 - Post (with safety ladder)
Box 2 Contents:
1 - Hardware Kit (with separate packaging list)
2 - Ramp pin
2 - Front Wheel Stop
4 - Sheave Cover
2 - Approach Ramp
1 - Coupler, ¼”NPT
2 - Recoil Hose
1 - Power Unit 220v/1Ph/3hp
10ft - 1/4” DIA. Polytube
10ft - 3/8” DIA. Polytube
1 - Hose Guard
1 - Hydraulic Hose Assembly (16ft. lg.)
2 - Cable Tie
1 - Air Valve & Filter Assembly
1 - Flow Control
1 - Installation & Operation Manual