36 of 76
NOTE: If anchors do not tighten to required torque, OR project more that 2-1/4" above
the concrete surface due to floor slope, contact a foundation engineer to determine the
best course of action.
Figure 29: Embedment Figure 30: Leveling
NOTE: The 3/4” 5 ½” lg. wedge anchor bolts supplied must have a minimum
embedment of 3¼” into concrete floor (see Figure 29).
NOTE: In cases where the floor is extremely out of slope, the mechanical safeties may
not engage on the same lock.
DO NOT use more than 1/2" (13mm) of shims. Anchor bolt supplied
allow for a maximum of 1/2" (13mm) of shim. If more than 1/2"
(13mm) of shims are required, DO NOT proceed with installation and contact Snap-on
Equipment Technical Support for further details.
To Next Page
Loading...
