Engineering manual - SAB 193-233-283 S A-frame (including ATEX)
14/168
008831 en 2020.10
Signs and warnings
2. Signs and warnings
This chapter describes:
• how to identify equipment from Johnson Controls Denmark
• all warning signs used on equipment delivered by Johnson Controls Denmark
• how information important to safety of personnel and equipment is presented in instruc-
tions belonging to equipment delivered by Johnson Controls Denmark
2.1 Main users
Information concerning Signs and warnings is intended for all users.
The following describes the importance of the individual signs attached to the Johnson Controls
Denmark products.
Before a compressor/unit is put into operation, it must be fitted with the warning signs belonging
to the type of compressor/unit in accordance with the rules and regulations in force.
2.2 Identification of Johnson Controls Denmark equipment
All Johnson Controls Denmark equipment can be identified by one or several name plates on the
unit. The name plates are illustrated on the following pages.
To Next Page
Loading...
Need help?
General
