Engineering manual - SAB 193-233-283 S A-frame (including ATEX)
008831 en 2020.10
159/168
Commissioning instructions
15.7 Commissioning checklist
Compressor serial no.:
Date: Name:
Check before start-up
Read and understand all Sabroe manuals (compressor, UniSAB , chiller, etc.)
Read and understand manuals for third party components (electric motors, valves, etc.)
Check unit installation and vibration damper adjustment
Carry out functional testing of safety equipment
Read the opening pressures on all safety valves, and check that they are correct
Carry out vacuum test
Check UniSAB set-up (see list of settings), and check VSD set-up, as applicable
Check oil level
Check that the heating element in the oil has been on for 6-8 hours before start
Take a sample of the primary refrigerant (must be free from water, air, etc.)
Check that the motor rotation direction is correct
Check that the coupling is aligned
Check that compressor cooling is connected correctly
Check that the plant is not leaking
Check that the valves are in the correct position for operation
Check after start-up
Check that the capacity regulation system is working correctly
Check the refrigerant charge (at full load)
Check the unit for vibrations
Check the unit for vibrations using VibraGuard (variable speed)
Make a start-up log at full load (on the back of this form)
Take out a representative lubricating oil sample after about 1 hour of operation, and save it
for minimum 1 year from commissioning date
Table 58: Commissioning checklist
To Next Page
Loading...
Need help?
General
