Macro Commands Configuration Tool Settings
35IFI-WS Installation and Operation Manual – P/N LS10050-000JC-E:A 12/11/2014
3.9 Macro Commands
Macro commands are created in the configuration tool which is launched from the workstation’s main menu
(Configure >Launch Configuration Tool).
Macro commands are created and edited on the configuration tool Screen Objects window. Administrators access the
Macro Editor function in the Tools menu (Tools > Macro Editor). The Administrator creates a macro command by
naming it and assigning it a macro command. The macro command’s Menu list of choices will be contingent on the
gateway type, point, and node type that is selected. Macro settings are saved when exiting the configuration tool and
clicking Ye s to the Save Changes prompt. Refer to the Intelligent Fire Integrator Configuration Tool Installation &
Operation Manual (P/N 53380) for additional information.
On the workstation, a macro command is activated in one of two ways:
•Clicking on a macro icon in the graphics display.
•Clicking on the Macros menu item on the workstation menu bar and selecting the desired macro from the list.
The Macro menu item displays only if the user has administrator-level privileges.
To Next Page
Loading...
Need help?
General
