LCD Message Display
8–2 iSTAR Ultra Installation and Configuration Guide
LCD Message Display
The iSTAR Ultra includes an LCD display for status and diagnostic messages. SW3 is an
onboard 16-position rotary switch. Most of the positions are used to control LCD diagnostics.
Figure 8-1 shows the location of the rotary switch SW3. See Table 8-1 on page 8-2 for a
summary of SW3 settings.
Figure 8-1: SW1 Location
Table 8-1: iSTAR Ultra Rotary Switch Functions
Position Description
0 ICU Block Off (Read/Write/Update) Display General Messages.
1 Display card data from last card read, 7 second LCD display (slow mode).
2 Display card data from last card read, 2 second LCD display (fast mode).
3 Display supervised input changes, 2 second LCD display (slow mode).
4 Display supervised input changes, 1 second LCD display (fast mode).
5 Display manual output changes (include readers and R/8 boards), 2 second LCD display
(slow mode).
6 Display manual output changes (include readers and R/8 boards), 1 second LCD display (fast
mode).
7 Not used.
To Next Page
Loading...
