Ports
4–8 iSTAR Ultra Installation and Configuration Guide
Ports
RS-485 1 and 2 (J12 and J13)
Used for Aperio Hubs and Schlage PIMs.
Each Port can support up to fifteen Hubs. Each Hub can support either one Reader or eight
Readers.
USB Type A - J8 and J9
Four type A ports used to communicate with ACMs and to import encryption keys from a
Certificate Authority using a thumb flash drive.
USB Micro A-B - J7
Not currently used. Future option.
RS-232 Diagnostic Port (P4)
Software House Tech Support and Engineering use for troubleshooting.
COMM Board Connector - J15
Not supported. Future option.
Visual Indicators
Power - DS1 and DS2
Indicate that power is supplied to the unit.
LCD
The LCD displays status and diagnostics messages.
Diagnostics are controlled by the rotary switch, SW3. See “SW3 Rotary Switch” on
page 4-4.
Contrast controlled by potentiometer, RV1.
The back light is on when door is open, off when door is closed.
Common LCD displays are:
Firmware version and Date/Time loaded.
Indication of whether a CFG Restore occurred.
FIPS self test.
Master Connected or Host Connected
To Next Page
Loading...
