Access Control Module
iSTAR Ultra Installation and Configuration Guide 5–15
Figure 5-13: Wet NO Latch
Wet Wiring for a Magnetic Lock
Magnetic Locks are normally energized so the GND and NC pins are used in this case. Notice
that jumper is in the Wet position, as shown in Figure 5-14 on page 5-15.
Figure 5-14: WET Magnetic Lock
Table 5-4 on page 5-15 summarizes the function and designation of the ACM LEDs.
Table 5-4: ACM LED Functions
LED Function Comment
DS21 Main Power - Reader Power - J4 12 Vdc
DS52 Main Power - LOCK 1 - J2 12 or 24 Vdc
DS54 Main Power - LOCK 2 - J3 12 or 24 Vdc
To Next Page
Loading...
