Switches
iSTAR Ultra Installation and Configuration Guide 4–7
Figure 4-2: Tamper -J1
The tamper switch controls many LEDs, to preserve power and also turns off the super bright
LED when the door is open. When the door is opened the small power LEDs are on. The LCD
is also off when the door is closed.
GCM Power - J4
12 Vdc @ 4.5 Amps max (Note: pin 1 on the left is +12 Vdc, pin 2 is GND.)
J14 SD Card
Located on the back of the GCM to the left of the SOM, near the Hard Reset switch. This non-
volatile memory is where backups are stored.
NOTE
The Tamper, Low Battery, and AC power fail inputs must be enabled and connected to
report for compliance with UL requirements.
Shielded cable must be used for AC Fail and Low Battery Input connections.
Once the Ultra GCM is powered on, you must follow the shutdown procedures described in
“Proper Shutdown Sequence” on page 7-6 to shutdown the Ultra GCM.
To Next Page
Loading...
