JR XP810-3 - Page 109

www.modelflight.com.au – World’s best source of JR products
3
. 9 Modulation Select
(
S
y
stem Set-U
p
Mode
)
The Modulation Selection Function enables your XP8 10 3 to
transmit to a variety of JR receivers that are already , or may soon
be, in existence. Y ou can select from either S-PCM or Z-PCM
mode, depending on the Central Processing Unit within your
receiver, or from PPM (Pulse Position Modulation—FM). Refer to
the receiver compatibility chart for the correct modulation.
Caution: After making modulation changes, you must press
either the UP and DN, or the DN and SEL keys simultaneously to
accept the new modulation type. If the Tx power switch is turned
OFF before this procedure, the modulation change will not be
saved.
Receiver Compatibility Cha
r
t
Tx Modulation Compatible # of Channels
Receivers & Brief Description
PPM (FM) NER-2 26 6 (micro)
PPM (FM) NER-2 28 8
PPM (FM) NER-3 27 x 7
PPM (FM) NER-5 27 x 7 (micro)
PPM (FM) NER-5 29 x 9 (micro)
PPM (FM) NER-54 9 9
PPM
(
FM
)
NER-6 00 6
(
micro
)
Tx Modulation Compatible # of Channels
Receivers & Brief Description
Z-PCM NER - 236 6 (micro)
Z-PCM
NER - 62 7XZ or
62 7 “G” series 7
Z-PCM NER - J3 29 P 9
Z-PCM NER - 91 0XZ 10
S-PCM NER - D9 40 S 10
S-PCM NER - 64 9S 9
In system Set-Up Mode, select Modulation Select using the U
P
and DN keys and press the UP and DN keys simultaneously t
o
access.
Model Numbe
r
Modulation
Model T
yp
e
Press the UP and DN keys or DN and
Select keys simultaneously to
accept the new modutation type and
to exit the S
y
stem Set-U
p
Mode
Press the DN and Select keys to
accept the new modulation and to
access the s
y
stem info dis
p
la
y
UP
DN SELECT CH CH CLEAR
To Data Transfer
function
To Data Reset
function
Modulation
selection SPCM,
ZPCM, or PPM
(
FM
)
Reset modulation
to SPCM
GLID 109