www.modelflight.com.au – World’s best source of JR products
This function is used to transfer all existing memorized data for a
model from one XP8
10
3 transmitter to another XP8
10
3 transmitter
.
Use the + and - keys to select models to be transferred and
activate by pressing the CLR key
.
T
o
avoid the loss of impor
tant data, re-confir
m
model names
when transferring.
Caution:
Please use special caution when copy function is
activated as existing data is replaced with new data.
Caution:
When the batter
y alar
m is activated (batter
y low), the
copy function is not operational.
ransmitting mode
Model numbe
Display indicates DSC cord is
not connected, or Tx power
switch is on/off
CLR start transmitting
transmitting counter
(0-100%)
make sure that the receiving
mode transmitter (Tx to be
programmed) is in the stand-by
condition.
Press the UP and DN keys
simultaneously to enter/exit the
S
Mode
Press the DN and Select key
simultaneously to access th
UP
DN
SELECT CH CH CLEAR
To Aux 2 input
select function
To Modulation
select function
Select
Transmitting/
Receivin
Mode
Press + or -
keys to select
models to be
transferred
T
ransfer Procedure
1.
Select the model number to be transferred (transmitting mode
side) through the model select function. (See page 66 for
infor
mation on Model Select Function.)
2.
Both transmitters: With the power switches OFF
, press the U
and DN keys simultaneously while inser
ting the trainer cord int
the DSC jacks of both transmitters.
3.
Both transmitters: Select the T
ransfer Fuction by pressing the
UP or DN key
. Then simultaneously press the UP and DN keys to
enter the T
ransfer Function.
4.
Receiving mode transmitter (Tx to be programmed): Press the
Select key until the screen reads "Receive." Select the receiving
model number by pressing the + or - keys. Next, press the CLR
key to activate the receiving stand-by mode.
5.
T
ransmitting mode transmitter (Tx with program to be
transferred): Press the CLR key to star
t transmitting data. Both
transmitters will indicate [End ok!] display when the transmitting
is complete.
To Aux 2 in
ut
UP
DN
SELECT CH CH CLEAR
Press to start
select function
To Modulation
select function
Transmitting/
Receiving Mode
select
Press + or -
keys to select
the receiving
model numbe
To Next Page
Loading...
Need help?
General
