JR XP810-3 - System Set-Up Mode Functions; Input Selection; System Set-Up Mode

www.modelflight.com.au – World’s best source of JR products
3 . S
y
stem Set-U
p
Mode Functions
3
.
1 S
y
stem Set-U
p
Mode
T o set the System Set-Up Mode, press the UP and DN keys
simultaneously and tur n the power switch from OFF to ON.
Functions are selectable by pressing either the DN or UP keys.
Individual settings are explained later at each function. In this
mode, ser vos are not activated, but operating signals are
transmitting (only when the Tx module is in place). However , us
e
extra caution not to interfere with other frequencies. By pressin
g
the DN and UP keys simultaneously , you can retur n to the norma
l
display, which allows the ser vos to again operate.
S
y
stem Set-Up Mode
[
INFO-DISP
]
P
g
. 66 Information Dis
p
la
y
Use either the UP
or DN key to scroll
through the menu
and access the
applicable function
Pg. 66 Model Selection and Copy Function
Pg. 67 Model Name Input
Pg. 68 Model Type Selection
P
g
. 68 Data Reset
P
g
. 69 Modulation Selection
P
g
. 70 Data Transfer
Pg. 72 Input Selection
–
A
ux 2, channels can be used for gyro
sensitivit
y
ad
j
ustment
HELI 64