www.modelflight.com.au – World’s best source of JR products
4
The T
rim Of
fset Memory Function allows you to test fly your
aircraft and correct for any built-in trim requirements. After you
adjust the aileron, elevator and/or rudder trim levers during test
flights, the trim levers are no longer in their center
, or neutral,
positions. The use of trim offset allows you to return them to their
central or neutral positions without readjusting the linkages.
This function is ver
y impor
tant when switching from model to
model. It allows your trims to remain in their neutral positions.
With the use of this function, you can easily switch among the
10
model memories without readjusting for each airplane’
s trim
positions.
In the Function Mode, select T
rim Of
fset Memor
y using the UP or
DN key and access by pressing the UP and DN keys
simultaneously
.
Press the UP and DN keys
simultaneously to enter/exit
the Function Mode
Press the DN and Select key
simultaneously to access th
Press either the + or - keys to
memorize the positions, then center
trims and
ress Clear to store
To Flap Knob
Ad
ustment function
UP
DN
SELECT CH CH CLEAR
Press Select, then Clear to reset all trim values to 0
To Differential Aileron Mixing
rim Of
fset
Example: aileron trim. T
rim is of
fset to left. Access the T
rim Of
fset
Function and see Figure 1 below
.
t this time, press the + or - keys and the display shows (2) and
memorizes the existing position. Next, retur
n trim to center and
press the CLR key
. Display shows (3) and memorizes the trim
of
fset value and the servo is retur
ned to its first trim position.
Note:
If trim is not retur
ned to the center
, the trim memor
y
position will not be stored.
Note:
If the of
fset value is too large, a warning will sound when
you retur
n the trim levers to center
, and the display shown in (4)
will appear
.
t this time, you should retur
n the applicable trim lever to the
corrected position. OVER will disappear from the LCD. It is easy
to recognize the applicable trim channel as it will be the one
next to where OVER appears on the LCD.
Press the CLR key to clear the trim of
fsets from the transmitter’
s
memor
y
.
It is recommended that you adjust the applicable
mechanical linkage accordingly
.
T
o
clear the trim of
fset adjustments, press the Select key and then
the CLR key
. The display will appear as Figure 5
.
T
o
exit from T
rim Memor
y Of
fset, press the UP and DN keys
simultaneously to exit the T
rim Memor
y Of
fset function.
To Next Page
Loading...
