JR XP810-3 - 3 2 Function Mode; List Mode; Model Select

www.modelflight.com.au – World’s best source of JR products
3
. 3 List Mode
(
Function Mode
)
T o enter the List Mode, press the DN and SEL keys
simultaneously . From this display , pressing the UP and DN keys
simultaneously will move the system from the list mode to the
function shown at the cursor . Note that the cursor is moved by
the UP and DN ke
y
s.
Press simultaneousl
y
to access function a
t
curso
r
Press to select either of
two Function List screens
UP
DN SELECT CH CH CLEAR
Inactive while in List Mode screen
3
. 4 Model Select
(
S
y
stem Set-U
p
Mode
)
The XP8 10 3 transmitter employs a memor y function which
memorizes data for up to 1 0 individual aircraft. All settings
along with type selection, function, and dif ferent aircraft are
used by one transmitter . For example, Model 1 is helicopter and
Model 2 is airplane. T
o avoid confusing models, inputing model
names for each aircraft is recommended (see page 2
9). Pres
s
the UP and DN keys simultaneously and tur n the power switc
h
ON to access the System Set-Up Mode.
The display below shows the model selection function.
model number
(
1-10
)
model name
(if dot is shown, model
name is blank)
modulation
type
Press UP and DN keys
simultaneously to exit the
S
y
stem Set-U
p
Mode
Press UP and Select keys
simultaneously to access the
S
y
stem Mode info dis
p
la
y
To Model Name function
UP
DN SELECT CH CH CLEAR
Function select
(
select model/co
py)
Model selection
To Info Dis
p
la
y
function
(
1-10
)
A
CRO 28