JR XP810-3 - Data Reset; Model Type Selection

www.modelflight.com.au – World’s best source of JR products
3
. 7 Model T
yp
e Selection
(
S
y
stem Set-U
p
Mode
)
The XP8 10 3 is capable of per for ming as a helicopter , airplane
or glider radio with full functions for each.
It can also memorize data for 1 0 models individually .
Note: If the power switch is tur ned OFF immediately after
selecting the new model type, the change will not be saved.
T o change and save the model type press the UP or DN keys, or
press UP and DN keys or DN and SEL keys simultaneously . At
this time, existing model data is replaced by the model type
aircraft data selected. Be sure to confirm the model name to
prevent accidental loss of your important data. T
o cancel this
function, return to for mer model type or tur n the power switch
OFF.
Note: When you select helicopter or glider model type on thi
s
transmitter , allocation of lever switches, etc., will also change
.
Please refer to the helicopter or glider section of this instructio
n
manual for their functions.
Model numbe
r
Arrow indicate
s
existing mode
l
t
yp
e
Model name (if blank,
no model name has
been stored)
Helicopter
Airplane
Glider
Press simultaneously t
o
change and save mode
l
t
yp
e
Press the DN and Select key
s
simultaneously to access th
e
s
y
stem mode info dis
p
la
y
UP
DN SELECT CH CH CLEAR
To Data Reset
function
To Model Name function
Press to move
arrow and select
model t
yp
e
3
. 8 Data Reset
(
S
y
stem Set-U
p
Mode
)
The Data Reset Function allows you to reset all the functions and
settings for the current model to the factory pre-set conditions.
Resetting does not af
fect the data already programmed for other
models. Be sure to confirm that you need to reset the data of the
currently indicated model in order to prevent accidental loss of
valuable data.
Note: If a model name has been input and is reset, the model
name will not be removed, only the data. Please refer to the
Model Name Function for information on how to change the
model's name.
T o access Data Reset, select Model Reset in System Set-Up and
press the UP and DN keys simultanelously
.
model number to
be reset
Press simultaneously to
exit the System Set-Up
Mode
UP
DN SELECT CH CH CLEAR
To Modulation Select
function
To Model Type Select
function
Press to return to
factor
y
p
reset data
HELI 68