JR XP810-3 - Flap to Aileron Mixing

www.modelflight.com.au – World’s best source of JR products
4 . 8 Fla
p
to Elevator Mixin
g
(
Function Mode
)
, cont.
Flap Operating Direction
(D=Down, U=Up)
Indicates the
function being
selected:
↓
Rate
↓
SW
SW OFF appears when the Flap Mixing
is in the middle or lower position
Flap to Elevator Mixing V alue (± 125%)
Indicates current Mixing Switch acitvated
Fla
p
Offset
V
alue
Press the UP and DN keys
simultaneously to enter/exit
the Function Mode
Press the DN and Select key
s
simultaneously to access th
e
Function Mode List Dis
p
la
y
To Fla
p
to Aileron Mixin
g
UP
DN SELECT CH CH CLEAR
Press to return the
function
To Differential Aileron
Mixin
g
function
Function
Selection
↓
Rate
↓
SW
↓
Offset
A
t rate, press to
increase/decrease
Mixing V
alue (± 125%)
At switch, press to
chan
g
e switch selection
mixing value to zero or
to return the active
mixin
g
switch to ON
4 . 9 Fla
p
to Aileron Mixin
g
(
Function Mode
)
The purpose of the Flap to Aileron Mixing Function is to allow
you to couple the ailerons to the flaps. This will enable you to
droop the aileron with the flaps to increase lift. If you should find
it necessar y to redefine the neutral position of the ailerons, a
mixing offset is also provided. Note that the of
fset value for the
Flap to Aileron Mixing Function is also the same as the point
established for the flap to elevator mix, if utilized. When you
need the mix direction reversed, press the - key to increase
minus mixing.
In Function Mode, use the UP and DN keys to select Flap to
A
ileron Mixing and access by pressing the UP and DN keys
simultaneously .
Selection of Operational Switch
the applicable switch is in the OFF position, SW OFF flashes in
the left upper corner and increase or decrease mixing value is
not applicable. Press the CLR key to set ON.
Note that the of fset value set by this function is the same as flap
to elevator mixing.
ON Always On
MIX Mixing Switch Is For ward
FLP-D Flap Switch is Down Position
F-U&D Flap Switch is Up or Down Position
Switches for Mixing Function ON/OFF position are listed in the
cha
r
t at ri
g
ht and can be accessed with the + or - ke
y
s. When
GLID 119