JR XP810-3 - Page 71

www.modelflight.com.au – World’s best source of JR products
3
.
1
0 Data T ransfe
r
, cont.
When there is a data receiving failure during transmitting, the
counter will stop. At this time, press the CLR key to stop the
receiving condition. Check to be sure the receiving counter is
operating nor
mally and ended with 1 00%. If there is any failure
of transferrin
g
, the dis
p
la
y
will a
pp
ear as follows:
model number to
existing model numbe
r
CLR key to start
stand-by receiving
be copy
Receiving counter (0-100%)
+o
r
- to select models
To Aux 2 in
p
ut
UP
DN SELECT CH CH CLEAR
Press to standby
selection function
To Modulation
select function
Transmitting/
Receiving Mode
chan
g
e
Receiving
model select
receiving/stop
receivin
g
condition
When the receiving counter is stopped or you see ERROR
indicated, check the DSC cord connections or trainer cord
conditions and tr
y again. When data has been received
correctly , you will see [End ok] display . Be sure that the
receiving mode transmitter is in stand-by condition first. Then on
the transmitting transmitter press the CLR key to star t transmitting.
A
lso ensure that when transferring is complete, previous data
stored in the receiving side transmitter is covered by new data
transferred.
Note: This function does not work when the batter y alar m is
flashing.
stand-b
y
receivin
g
condition
stand-by
condition
receiving
counter
0-100%
To Aux 2 in
p
ut
UP
DN SELECT CH CH CLEAR
Press to start
select
To Modulation
select
Transmitting/
Receiving Mode
select
transmittin
g
HELI 71