JR XP810-3 - Page 115

www.modelflight.com.au – World’s best source of JR products
4 . 4 T ravel Ad
j
ust
(
Function Mode
)
The purpose of T ravel Adjust, also known as endpoint
adjustment or adjustable travel volume, is to offer you precise
ser vo control deflection in either direction of ser vo operation.
The travel adjust range is from 0-1 5 0% (0 degrees to 6 0
degrees) from neutral and it can be adjusted for each direction
individually
. The factor y default (data reset) value is 1 00% for
each direction of servo travel.
In the Function Mode, use the UP or DN key to select the T ravel
A
djust function and access by pressing the UP and DN keys
simultaneously .
Channel being programmed
SPOI Spoiler
AIL1
Aileron
ELEV Elevator
RUDD Rudder
AIL2 Right Aileron
FLAP Flap (Left)
AUX2 Flap (Right)
A
UX3 Extra channel
(
Aux3
)
Press the UP and DN keys
simultaneously to enter/exit
the Function Mode
Press the DN and Select key
s
simultaneously to access th
e
Function Mode List Dis
p
la
y
To Elevator/Fla
p
UP
DN SELECT CH CH CLEAR
Reset travel
Mixin
g
function
To Sub- Trim
function
Press to display
channels 1-4 and
5-8
(
2 screens
)
Channel
Selection
Press to increase or
decrease travel value;
move stick or switch to
manipualte arrow to the
position to be adjusted
(
hi
g
h/low, left/ri
g
ht
)
value to factory
p
reset
(
100%
)
4 . 5 Elevator
T
o Fla
p
Mixin
g
(
Function Mode
)
When the Elevator to Flap Mixing Function is activated and a
value of flaps is input, the flaps will be deflected each time the
elevator stick is used. The actual flap movement is independently
adjustable for both up and down elevator . The most frequently
used application is up elevator/down flaps. When used in this
manner , the aircraft pitches up much more quickly than nor mal
— helpful in tight ther mal tur ns.
In Function Mode, use the UP and DN keys to select Elevator to
Flap Mixing function and access by pressing the UP and DN
keys simultaneously .
Selection of Operational Switch
Elevator to flap mixing can be turned ON/OFF with a variety of
switches and switch positions. Below is a list of the switch
options.
Note: When applicable switch is OFF , SW OFF flashes
in the left upper corner and increase or decrease mixing value is
not applicable.
MIX Mixing Switch Is For ward
FLP-D Flap Switch Down Position
FLP-U Flap Switch Up Position
ON Always On
GLID 115