JRC J-Marine NeCST - Page 269

5-4
Contents
Cause
Action
2. Touch Panel Display unit
3. Display processing unit
There is a problem in the data
processing unit.
Request repairs to the distributor.
AIS information is not
displayed.
Communication is not set
correctly.
Request setting to the distributor.
The power supply for the AIS
device is not turned on.
Turn on the power supply of the AIS
device.
The AIS device does not receive
other ship’s information.
Check the condition of the AIS device.
Not output from VDR or SLC.
Check the status of VDR or SLC.
The AIS display setting in the
display processing unit is
incorrect.
Start NeCST and tap the gear icon at
the top of the screen. Set Max Ships
in the AIS tab.
The Web server of the data
processing unit is not activated.
Turn off the power supplies of this
product and turn on power supplies in
the following order.
1. Data processing unit
2. Touch Panel Display unit
3. Display processing unit
There is a problem in the data
processing unit.
Request repairs to the distributor.
The bearing of the
gyro compass is not
displayed.
Alternatively, the
bearing rotation
direction is not
displayed correctly.
Communication is not set
correctly.
Request setting to the distributor.
The power supply for the gyro
compass is not turned on.
Turn on the power supply for the gyro
compass.
Not output from VDR or SLC.
Check the status of VDR or SLC.
The Web server of the data
processing unit is not activated.
Turn off all the power supplies of this
product and turn on the power
supplies in the following order.
1. Data processing unit
2. Touch Panel Display unit
3. Display processing unit
There is a problem in the data
processing unit.
Request repairs to the distributor.
Log is not displayed
correctly.
Alternatively, the
values are not
displayed
correctly.
Communication is not set
correctly.
Request setting to the distributor.
The power supply for the log
device is not turned on.
Turn off the power supply for the log
device.
Not output from VDR or SLC.
Check the status of VDR or SLC.
The Web server of the data
processing unit is not activated.
Turn off all power supplies of this
product and turn on power supplies in
the following order.
1. Data processing unit
2. Touch Panel Display unit
3. Display processing unit
There is a problem in the data
processing unit.
Request repairs to the distributor.
Rudder angles are
not displayed.
Alternatively, the
values are not
Communication is not set
correctly.
Request setting to the distributor.
The power supply for the rudder
angle indicator is not turned on.
Turn on the power supply for the
rudder angle indicator.