5-53
a) Setting change of each item
Each item settings are as follows
The area of setting
1. CH A
2. CH B
・ Item 1 and 2 are setting of the channel numbers.
・ Select 1.CH A, CH A can be changed. Select 2.CH B CH B can be changed.
・ Input the channel number with ▲ key or ▼ key and press ENT key. And then the setting is valid.
・ After 1.CH A setting, the cursor move to 2.CH B. The setting procedure is same as CH A.
3. TX/RX MODE
Set the CH A/CH B (specified at item 1,2) TRX mode to “TX/RX” or “RX”.
If “TX/RX” is selected, the setting is changed into transmitter-receiver mode. If “RX” is selected, the
setting is changed into receiver mode.
・ Select 3. TX/RX MODE CH A,B with ▲ key or ▼ key and select the CH A/B mode from the
selection (shown in the table below).
Order Selection Dialog
1 TX/RX, TX/RX CH A and B set transmitter- receiver mode
2 TX/RX, RX CH A set transmitter-receiver, CH B set receiver
3 RX, TX/RX CH A set receiver, CH B set transmitter-receiver
・ Press ENT key and confirm the setting.
・ It is not acceptable that Sets both CH A and CH B to “RX”.
4. TX POWER
Select 4. TX POWER, transmission power can be set.
・ Select the transmission power from “HIGH” and “LOW” with ▲ key or ▼ key.
・ If “HIGH” is selected, the power is set 12.5W, if ”LOW” is selected, the power is set 1W.
・ Press ENT key and confirm the setting.
5. ZONE SIZE
Select 5. ZONE SIZE, zone size width can be input.
・ Press ▲ key or ▼ key to input the zone size width. (Input range; from 1NM to 8NM.)
・ Press ENT key and confirm the input.
6.AREA(NE)
N 15°22.33’
E 145°59.99’
7.AREA(SW)
N 14°22.33’
E 143°59.99’
5.ZONE SIZE : 5NM
1.CH A : 1222
2.CH B : 2222
3.TX/RX MODE: TX/RX,TX/RX
(CH A ,CH B )
4.TX POWER : HIGH
To Next Page
Loading...