JRC JHS-183 - Page 81

5-55
b) Check of the setting
Check the regional management setting whether it is based on the restriction or not.
If there are no errors, the setting can be saved
Press SUB key at the setting screen, SUB menu screen is displayed.
CHECK ･････ Check the setting whether it is based on the restriction or not
SAVE ･･･････ Save the setting, in case there are no problems.
LIST ････････ See the saved data (up to 8 setting)
CLEAR ･･････ Clear the contents that is being set
EXIT ････････ Leave the SUB menu and return to SET UP menu
Select [CHECK] and push ENT key, the popup screen which shows the result is appeared.
Result of checking
Indication note
OK [SAVE] can be selected
NG 20NM>AREA,AREA>200NM The range is under 20NM or over 200NM.
NG AREA CORNER ERROR
(*1)
Each of the distances of 3 area’s corners is within 8NM.
NG AREA 500NM OVER Set the area separated 500NM from own ship’s location.
NG CHANNEL ERROR Set by invalid channel
NG OTHER ERROR Set by other invalid matters
NG OVERTIME ERROR No response from transponder
(*1)
：In case of the condition below, AREA CORNER ERR is appeared.
○： ×：
SUB key
Area 1
Area 2
Area1
Area 2
No area
New setting
area
Within 8nm each
3 area’s corner
within 8nm each
OK screen
NG screen
SUB/CLR key
REGIONAL CHANNEL
1.CH A:2087
2.CH B:2088
3.TX
/
RX MODE CH A,B
:TX
/
RX, TX
/
RX
4.TX POWER:HIGH
▼
5.ZONE SIZE:5NM
1
/
3
REGIONAL CHANNEL
*SUB MENU*
[
CHECK
]
[
SAVE
]
[
LIST
]
[
CLEAR
]
[
EXIT
]
REGIONAL CHANNEL
*SUB MENU*
[
CHECK
]
[
SAVE
]
[
LIST
]
[
CLEAR
]
[
EXIT
]
REGIONAL CHANNEL
CHECK RESULT:OK
[
OK
]
REGIONAL CHANNEL
NG 20NM>AREA,
AREA<200NM
[
OK
]