JRC JHS-183 - Page 82

5-56
REGIONAL CHANNEL
▲
4.CH A:2087
CH B:1060
TX
/
RX MODE
A,B: RX, TX
/
RX
TX PO
W
ER:HIGH
▼
ZONE SIZE:5NM
REGIONAL CHANNEL
▲
SOURCE:
BROADCAST MSG.22
MMSI:123456789
UTC:
2012
/
05
/
10 08:45
c) Save the setting
If the result is OK, the setting is saved by transponder.
While the result is “NG”, [SAVE] can not be selected.
If the setting is saved normally, “SAVE OK” is appeared.
d) Confirmation of saved data
Select [LIST] in the SUB menu, Channel management information lists are displayed.
The list can be scrolled by ▲ key or ▼ key.
If CLR key is selected, the display is switched to SUB menu screen.
If there are no saved data, “NO DATA” is appeared.
Indicates the list number
If there are ▲ or▼ marks on the left side,
This means the list continues.
The last data indicates the time
registered.
e) Regional setting change
If the regional channel setting is changed, Popup is appeared as shown below.
REGIONAL CHANNEL
*SUB MENU*
[
CHECK
]
[
SAVE
]
[
LIST
]
[
CLEAR
]
[
EXIT
]
REGIONAL CHANNEL
SAVE OK
[
OK
]
CH MANAGEMENT
CHANGE
[
OK
]