JRC JHS-770S - Name a Controller

Settings & Registrations
5-6
5.3.4 Name a controller
When connecting multiple controllers, each controller can be named respectively to make identification easier.
The name of each controller is always displayed on the top left of the screen.
■ Procedure ■
1
1
1
.
.
.
Press MENU , and through hierarchical menus,
select the 9.3 My controller.
The screen as shown at right will be displayed.
2
2
2
.
.
.
Move the cursor to the 4. Name with the numeric
keypad or jog dial.
3
3
3
.
.
.
Press ENT to name the controller.
 Up to 10 alphanumeric characters available.
 Assigned "StationX (X: address No.)" by default.
 The following characters are available.
・ Alphabet (capital and small letters)
・ Numbers 0 - 9
・ The following signs, space and determination(
◄ ).
[ ] _ " # % & ' ( ) ? @ + - / = : ; < >
4
4
4
.
.
.
Select a character and press ENT one by one.
 To change the character at the cursor position, rotate the
jog dial to select the character, and press ENT to move
the cursor to the right. Further, when using the numeric
keypad to input numbers, pressing ENT is not needed.
 Only to move the cursor to the right, press ENT.
 To return to the previous letter, press CANCEL .
 To complete the name entry of 10 characters long, press
ENT after selecting the last character by the jog dial.
Or if less than 10 characters long, following the name,
select the determination as shown at right, and press ENT.
The characters sequence shown by turning the jog dial is as follows.
◄ A B C D E F G H I J K L M N O P Q R S T U V W X Y Z a b c d e f g h i j k l m n o p q r s t
u v w x y z [ ] _ " # % & ' ( ) ? @ + - / = : ; < > 0 1 2 3 4 5 6 7 8 9
(space)
9.3)My controller
1.LCD adjustment
2.Sound
3.User key assign
4.Name :[Station1 ]
5.Hook switch: Valid
6.Off-hook notice: OFF
0.Back
9.3)My controller
1.LCD adjustment
2.Sound
3.User key assign
4.Name :[Station1 ]
5.Hook switch: Valid
6.Off-hook notice: OFF
0.Back
9.3)My controller
1.LCD adjustment
2.Sound
3.User key assign
4.Name :[Station1 ]
5.Hook switch: Valid
6.Off-hook notice: OFF
0.Back
9.3)My controller
1.LCD adjustment
2.Sound
3.User key assign
4.Name :[Bridge1 ◄ ]
5.Hook switch: Valid
6.Off-hook notice: OFF
0.Back
Note