JRC JHS-770S - Receiving with Scanning

Operation
4-7
4.2.4 Receiving with scanning
Scanning function enables to watch multiple channels (additional channels) with the priority channel
(CH16). If found receiving signal on the additional channels, the dwell time on that channel will be
longer, but continued to watch the CH16 alternatively. The scan mode can be selected from the
following modes.
・ All CH scan Mode: Scans all channels in the current channel mode.
・ Memory CH scan Mode: Scans all memory channels.
・ Select CH scan Mode: Scans the specified range of channels.
■ Procedure ■
1
1
1
.
.
.
Press FUNC  2SCAN .
The menu will be displayed as shown at right.
2
2
2
.
.
.
Move the cursor to the desired item and
press ENT using the jog dial, or press the
item number by a numeric key directly.
 If selected "1. All CH scan" or "2. Memory CH
scan", scanning starts immediately.
 If selected "3. Select CH scan", specify the
channel range as described below.
1) To set the start channel (From):
Press ENT and after entering the
channel number, press ENT again.
2) To set the stop channel (To):
Press ENT and after entering the
channel number, press ENT again.
3) To start the scanning:
Select Execute and press ENT. Then
starts the scanning as shown at right.
- Disabled to scan when the channel
region is Inland Waterways (IWW).
- CH70 will be skipped, even if
contained in the scanning range.
3
3
3
.
.
.
To terminate scanning, press CANCEL .
 After terminated, the radiotelephone will be set
on the last additional channel. (The example at
right shows when stopped on CH12.)
 Scanning will be also terminated when detected
off-hook, PTT ON, or CH16 or DISTRESS
key pressing.
- While scanning, the radiotelephone scans CH16 and the additional channels
alternatively in a cycle of 0.14/0.86 seconds.
- If the squelch is opened on the CH16, paused scanning and continues to watch on
7.1)Scan
1.All CH scan
2.Memory CH scan
3.Select CH scan (ITU)
- From : CH 01
- To : CH 88
- Execute
0.Back
Note
7.1)Scan
1.All CH scan
2.Memory CH scan
3.Select CH scan (ITU)
- From : CH 01
- To : CH 88
- Execute
0.Back
Note
Station1 TIME 23:59(UTC)
POS 89ﾟ59'S
EXT 179ﾟ59'W
10
CH
CH70
CH
SW
SCAN
16&
[ITU]
SQL
Station1 TIME 23:59(UTC)
POS 89ﾟ59'S
EXT 179ﾟ59'W
12
CH
CH70
[ITU]
SQL
CH
SW