JRC JHS-770S - Squelch Settings of each Channel (Preset Squelch)

Operation
4-13
4.2.10 Squelch settings of each channel (preset squelch)
The adjusted squelch value can be stored with respect to each channel as a preset squelch. The
handling of the preset squelch will be as follows.
・ If stored the squelch value, the preset squelch will be always set just after the channel selection.
・ While the preset squelch has been set, "p SQL" will be indicated on the status display.
・ If turned the SQL control after setting the preset channel, the preset value will be canceled
immediately and the SQL control will be available.
・ The preset squelch value can be cleared with respect to each channel or each channel region.
■ Procedure ■
1
1
1
.
.
.
After selecting the desired channel, press
MENU and through hierarchical menus,
select the 7.7 CH SQL setting.
2
2
2
.
.
.
Turn the SQL control to the appropriate
position.
The SQL value as shown at right will be
changed corresponding to the SQL control
position.
3
3
3
.
.
.
Press ENT.
The cursor will move to the right.
4
4
4
.
.
.
To complete the squelch setting for the
channel, select "Set" and press ENT.
- To clear the preset squelch values with respect to each channel, after selecting the
channel, select Erase and press ENT at the step 3 above.
- To clear the preset squelch values with respect to each channel region, in the
condition of that channel region, move the cursor to the 2. All clear and press ENT.
- The above operation is also available on a popup menu displayed when pressed both
of FUNC and CANCEL simultaneously on the status display.
7.7)CH SQL setting
SQL value [052]
1.Preset : Set
2.All clear
0.Back
7.7)CH SQL setting
SQL value [041]
1.Preset : Set
2.All clear
0.Back
7.7)CH SQL setting
SQL value [025]
1.Preset : Set
2.All clear
0.Back
7.7)CH SQL setting
SQL value [025]
1.Preset : Set
2.All clear
0.Back
Note