JRC JHS-770S - Checking the Setup Condition

Maintenance & Inspection
6-7
6.4 Checking the setup condition
The system information can be confirmed for use in maintenance and inspection.
6.4.1 System information
The following describes the procedure to display such as the ID numbers or peripheral connection conditions.
■ Procedure ■
1
1
1
.
.
.
Press MENU , and through hierarchical menus,
select the 8.3 System information.
The screen as shown at right will be displayed.
If necessary, scroll with the jog dial.
The confirmable information is described below.
Item Name Contents Notes
Self-ID Own ship's identification number (9-digit MMSI)
Group-ID The identification number of the group own ship belongs to
ATIS-ID The ATIS number for European inland waterways
Num of CTLRs The number of connected controllers
Own CTLR ID The address number of this controller
WKR The setting status to use the watch-keeping receiver Default setting: Valid
User key asgn The menu assigned to the user defined key
Priority CH The registered priority channel number Default setting: CH16
Hook switch The setting status to use the handset hook detection Default setting: Valid
TX monitor
The setting status to monitor communications of a controller at the
other controllers and the external speaker
Default setting: ON
Alarm wake-up
The setting status to use the automatic startup function in sleep
mode if receiving a distress signal
Default setting: ON
AIS info The AIS connection status (Receiving/ Disrupted/ Invalid)
AME info The AME connection status (Normal/ CS error/ Invalid)
Serial number The serial product number of the JHS-770S/780D
6.4.2 Software version
To confirm the software version, press MENU and
through hierarchical menus, select the 8.4 Software
version.
The software version number of the transceiver and
controller will be displayed as shown at right.
8.3)System information
Self-ID :123456789
Group-ID :012345678
ATIS-ID :9431011234
Num of CTLRs :4
Own CTLR ID :2
WKR :Valid
User key asgn :AIS screen
Note
8.4)Software version
- Transceiver : 1.00
- Controller : 1.00
0.Back