JRC JHS-770S - Printer Property

Settings & Registrations
5-14
5.6.2 Printer property
When connecting the printers, configure the conditions as appropriate according to the printer type, as follows.
■ Procedure ■
1
1
1
.
.
.
Press MENU , and through hierarchical menus,
select the 9.7 Printer property.
2
2
2
.
.
.
Select the intended printer and press ENT.
When selected the 1. Controller printer, the screen at right
will be displayed.
3
3
3
.
.
.
Move the cursor to the desired item and press ENT.
The cursor will move to the right. After that, select the
condition as appropriate and press ENT.
The content and the selective conditions of each item are as follows.
Printer type Selective item Content
Selective conditions
( : Factory default)
Connection Connection status and the printer type None/ Serial
Data out Printing method for the DSC message Auto/ Manual
Baudrate Transmission speed to the printer 4.8k/ 9.6k/ 38.4kbps
Flow control Handshake setting with the printer Hard/ None
Controller printer
Print direction Printing sequence of the lines
Invert/ Upright
Connection Connection status and the printer type None/NKG-52/Centronics
Data out Printing method for the DSC message Auto/ Manual
Transceiver printer
Print direction Printing sequence of the lines
Invert/ Upright
(NKG-52: “Invert” only)
Note
9.7)Printer property
1.Controller printer
2.Transceiver printer
0.Back
9.7.1)Controller printer
1.Connection :None
2.Data out :Auto
3.Baudrate :4.8k
4.Flow control :Hard
5.Print direction:Invert
0.Back
9.7.1)Controller printer
1.Connection :None
2.Data out :Auto
3.Baudrate :4.8k
4.Flow control :Hard
5.Print direction:Invert
0.Back