JRC JHS-770S - Disabling the Hook Switch

Settings & Registrations
5-7
5.3.5 Disabling the hook switch
The hook switch for the handset can be disabled not to set to CH16 by returning the handset to the cradle.
(As a factory default setting, the hook switch has been set to “Valid”.)
■ Procedure ■
1
1
1
.
.
.
Press MENU , and through hierarchical menus,
select the 9.3 My controller.
2
2
2
.
.
.
Move the cursor to the 5. Hook switch with the
numeric keypad or jog dial.
3
3
3
.
.
.
Press ENT.
The cursor will move to the right.
4
4
4
.
.
.
Select the condition and press ENT with the jog dial.
 When selecting “Invalid”, deletes the line of “6. Off-hook
notice” and the cursor will move to 0. Back.
 To finish this menu, place the cursor on the 0.Back
and press ENT, or on any one of the selective items
and press CANCEL .
When selecting “Valid” and then set the
condition of the “6. Off-hook notice” to ON,
the popup screen as shown at right will be
displayed if left the handset without returning
to the cradle.
9.3)My controller
1.LCD adjustment
2.Sound
3.User key assign
4.Name :[Bridge1 ]
5.Hook switch: Valid
6.Off-hook notice: OFF
0.Back
9.3)My controller
1.LCD adjustment
2.Sound
3.User key assign
4.Name :[Bridge1 ]
5.Hook switch: Valid
6.Off-hook notice: OFF
0.Back
9.3)My controller
1.LCD adjustment
2.Sound
3.User key assign
4.Name :[Bridge1 ]
5.Hook switch: Valid
6.Off-hook notice: OFF
0.Back
9.3)My controller
1.LCD adjustment
2.Sound
3.User key assign
4.Name :[Bridge1 ]
5.Hook switch: Invalid
0.Back
Note
Station1 TIME 23:59(UTC)
POS 89ﾟ59'S
EXT 179ﾟ59'W
16
CH
ITU
SQL
CH70
- Attention -
Remaining in the
off-hook condition.
[ OK ]