JRC JHS-770S - 5 SETTINGS & REGISTRATIONS

Settings & Registrations
5-1
5. SETTINGS & REGISTRATIONS
This chapter describes the procedure for settings and registrations for the date and time manually,
the contact lists for DSC calls, advanced DSC settings, and other settings for the equipment.
5.1 Date and time setting
Normally, the date and time will be updated automatically if importing GPS information. But if necessary, input
these parameters manually as follows.
CAUTION
The time described below means the present time, and is different from the time in the
menu 9.2 POS/TIME that means the time when the position information is valid.
■ Procedure ■
1
1
1
.
.
.
Press MENU , and through hierarchical menus,
select the 9.1 Clock.
2
2
2
.
.
.
To input the date, press ENT.
Input the year, month, and date with the numeric keypad
or jog dial. (When using the jog dial, select the value
and press ENT for each digit.)
3
3
3
.
.
.
After completed the above steps, the cursor will
move to 2. Present time.
9.1)Clock
1.Date :'06-12-31
2.Present time : 23:59
3.Display form
- Type : Time,pos
- UTC/LT : UTC
- LT diff : :
- Date format :'YY-MM-DD
0.Back
9.1)Clock
1.Date :'06-12-31
2.Present time : 23:59
3.Display form
- Type : Time,pos
- UTC/LT : UTC
- LT diff : :
- Date format :'YY-MM-DD
0.Back
9.1)Clock
1.Date :'06-12-31
2.Present time : 23:59
3.Display form
- Type : Time,pos
- UTC/LT : UTC
- LT diff : :
- Date format :'YY-MM-DD
0.Back