Operation
4-4
4.2.2 Turning OFF the power
■ Procedure ■
1
1
1
.
.
.
Press and DIM simultaneously.
After that, the power-off process is activated
according to the controllers' situation.
When using multiple controllers
Select the desired item below on the displayed popup
screen at right.
・ [OK]: Turns off the power.
・ [Sleep]: Sets the controller to sleep mode.
・ [Cancel]: Returns to the previous screen.
When using only one controller
Select the desired item below on the displayed popup
screen at right.
・ [OK]: Turns off the power.
・ [Cancel]: Returns to the previous screen.
In sleep mode, the controller becomes the following conditions.
・ Only the controller is powered off.
・ The ALM lamp turns green to indicate that the controller is in sleep mode,
・ When receiving a distress call, the controller will be automatically turned on and
activate the alarm if the Wake-up setting in an installation menu is ON,.
・ Even if set the accessible controller to the sleep mode, the access right will not
move from the controller.
Note
PWR
CONT
Station1 TIME 23:59(UTC)
POS 89ﾟ59'S
EXT 179ﾟ59'W
16
CH
ITU
SQL
CH70
CH
SW
OK to power off
the VHF system?
[OK][Sleep][Cancel]
[OK]
Station1 TIME 23:59(UTC)
POS 89ﾟ59'S
EXT 179ﾟ59'W
16
CH
ITU
SQL
CH70
CH
SW
OK to power off
the VHF system?
[OK] [Cancel]
[OK]
To Next Page
Loading...
