Operation
4-29
3
3
3
.
.
.
When received the acknowledgement,
the screen shows the message with the
alarm as shown at right.
Pressing CANCEL stops alarm and after that,
pressing ENT returns to the status display.
(2) Test call
■ Procedure ■
1
1
1
.
.
.
After inputting the ship's address and
type (Test), the sending confirmation
screen will appear.
The test call is also available in
menu 3. DSC test call, by entering
the station address only.
2
2
2
.
.
.
Press ENT to transmit the call.
After completed the transmission, the popup
screen shown at right will be displayed to wait
the acknowledgement.
If received no response for 5 minutes,
the screen will return to the step 1
mentioned above.
3
3
3
.
.
.
When received the acknowledgement,
the screen shows the message with the
alarm as shown at right.
Pressing CANCEL stops alarm and after that,
pressing ENT returns to the status display.
According to the condition of the station,
the acknowledgement may not be received
even if the equipment works normally.
2.1.2)Specific station
Address :123456789
Type :Test
To Next Page
Loading...
