13
JLR-7700 MK2 GPS Navigator
1.3 Configuration
The equipment consists of the units shown in the table below. Immediately inform our local sales office or
your distributor if any one of them is found missing.
In addition, the following items are available as the optional units.
Unit Model Quantity Remarks
Navigator NWZ-4570B 1
DGPS connection cable CFQ-8919 1 5m with connector (For navigator)
Power supply cable CFQ-3598B 1 1.8m with connector (For navigator)
DGPS receiver NNN-4331 1 With 15m cable
Screw mount MTV302007 1 (For DGPS receiver)
Fitting belt MPBP02520 1 set Include 2 belts (For DGPS receiver)
Junction box NQE-7700 2
Pole mounting kit MPBP30608 1
Connector 6-282-7SG-321 1 (For data output)
Copper plate 1 25W×2000×0.3t (For navigator)
Spare parts 1 set 2A fuse
Suppression ferrite E04SR200935A or equivalent 1 See the item 3.4.3 "Connection of
the DGPS Receiver" for the
mounting method
Mounting screws MPTG02342 1 set
Three self-tapping screws with washers
Instruction manual DC51-JLR7700M 1
Unit Model Uses
Output buffer NQA-602DC The buffer can divide the output from the
navigator to three other external equipment
connected in parallel.
AC power supply unit NBA-3581A The rectifier converts the AC power (100 or 200
VAC) into the rated power supply voltage of 24
VDC for NWZ-4570B.
Further, the 24 VDC power as supplied from the
battery may be connected to the navigator to
backup the AC power supply.
Printer NKG-22 Various information displayed on the navigator
information, SAT status and so on can be
printed out by connecting the DATA OUT
connector provided on the rear panel of the
navigator to the printer using the optional data
cable (CFQ-8921).
Data cable CFQ-8921 The data cable can used when it is necessary to
output data from the DATA OUT connector
provided on the rear panel of the navigator.
Extension cable 250V-MPYCYS-5 or The cable is used to extend the cable for the
250V-MPYCYS-7 DGPS receiver, which is recommended as the
standard extension cable.
To Next Page
Loading...
