JRC JLR-7700MKII - DGPS Receiver Mast Mounting

24
JLR-7700 MK2 GPS Navigator
3.1.3 Installation of the DGPS Receiver on the Mast
The following figure shows how to install the receiver on the mast.
Clamp
Minus screwdriver
1. Loosen the fitting belt screw
with a screwdriver to remove
the clamp.
2. Coil the fitting belt around mast
as shown below.
3. Tighten the clamp screw with
the screwdriver.
How to Install the Receiver on the Mast
DGPS receiver
NNN-4331
Screws, mounting
MTV302007
Fitting belt
MPBP02520
Mast
(φ26〜φ90)