JRC JLR-7700MKII - DGPS Receiver Connection

31
JLR-7700 MK2 GPS Navigator
Suppression ferrite
(E04SR200935A or equivalent)
Cable
3.4.3 Connection of the DGPS Receiver
See the description under the item 2.2 “ Rear Panel of the Navigator” for the connectors provided on the rear
panel of the navigator.
Keep the excessive DGPS connection cable away from the navigator by a
minimum of 30 cm after connecting it. Failure to observe the instruction can
cause interference to other radio equipment.
The navigator supplies the 12 VDC power to the DGPS receiver. The DGPS receiver is activated when the
equipment is turned the power on to receive information from the satellites and transmit it to the navigator.
① Securely insert the CFQ-8919 DGPS cable plug into the “GPS/DGPS” connector provided on the rear panel
of the navigator.
② Then, mount the suppression ferrite included in the package on the cable at a position closest to the GPS/
DGPS connector to eliminate any unwanted noise.
1
5
4
2
6
3
GPS/DGPS connector
Pin No. Remarks
1 12 VDC output
2 Ground
3 Data common (Ground)
4 GPS data input
5 GPS setting data output
6 Open
CAUTION