26
JLR-7700 MK2 GPS Navigator
3.2.2 Installation of the Navigator
Firstly, secure a space for the mount according to Fig. 3-1. Then, secure the mount by following the procedures
shown below.
(1) Determine the location to install the equipment. Mark the three mounting screw positions with a pencil or
equivalent. See the Fig. 3-2 for the mounting screw hole size.
(2) Secure the bracket at the installation location using the three self-tapping screws.
(3) Mount the equipment on the bracket and confirm that it is securely mounted.
(4) Adjust the orientation of the equipment to an optimum position.
Secure the bracket with the screws provided with the equipment. Failure to
observe the instruction can cause injury or property damage since the
equipment is likely to drop.
WARNING
To Next Page
Loading...
