50
JLR-7700 MK2 GPS Navigator
4.3.3.2 Setting the Display Unit
The distance can be displayed in either one of the two units, nm or km. The speed will be displayed in the unit
of knot (kt) if nm is selected, or in the unit of km/h (KH will be displayed on the display) if km is selected. The unit
is factory set to nm, press the key provided on the right hand side of the DISP UNIT to select the desired
unit.
4.3.3.3 Selection of the Data Output Format
Select the data format that was selected under the item 3.4.4 “Data Output”.
Any one of the following four data formats can be output, which are output from the DATA OUT connector
provided on the rear panel. (See the item 3.4.4 “Data Output”.)
Set the data format that can be received with the unit connected to the equipment by following procedure.
Press the MODE NAVIGATE and AUX keys, and input the password. Then, press the DATA 1 key
to select a desired type of data output.
The type of output for data 2 changes when the DATA 2 key is pressed. The screen returns to the
NAVIGATE screen when the ENT key is pressed.
・ The data format is factory set to NMEA version 2.1.
Data format Display on the screen
NMEA0180 0180
NMEA0183 0183
version 1.5 V1.5
NMEA0183 0183
version 2.1 V2.1
JRC format JRC
NMEA0183 0183
version 2.1/SEC 1SEC
Memo
・ All the bearing angles will be displayed in the magnetic compass mode if a correction value other than
zero is set.
・ The display will be in the magnetic compass mode (the symbol “m” will be shown after a given value) if
the magnetic variation is automatically corrected.
・ The correction value may change from one sea area to another. In this case, a new correction value
needs to be entered after coming the new area.
If select “NMEA0183 output per second” at DATA1 (or DATA2), the output of
DATA2 (or DATA1) is fixed to “NMEA0183 output per second” automatically,
and other data format can not be selected.
CAUTION
To Next Page
Loading...
