JRC JLR-7700MKII - Data Output Configuration

32
JLR-7700 MK2 GPS Navigator
1
7
6
3
4
5
2
See the item 4.3.3.3 “Selection of the Data Output Format” to switch the data format.
DATA OUT connector
Pin No. Remarks
1 Data 1 output (TTL level)
2 Data 1 common (GND) (TTL level)
3 Data 2 output ( ＋ ) (RS-422 level)
4 Data 2 output ( − ) (RS-422 level)
5 NC
6 Relay output (Log pulse), ＋ output
7 Relay output (Log pulse), − output
If select “NMEA0183 output per second” at DATA1 (or DATA2), the output of
DATA2 (or DATA1) is fixed to “NMEA0183 output per second” automatically,
and other data format can not be selected.
CAUTION
3.4.4 Data Output
The “DATA OUT” connector provided on the rear panel of the navigator can output data for the plotter, auto-
matic pilot, printer, remote display unit, fishfinder, radar and so on.
The format of data to be output can be selected from the following four types. Two each peripheral units can
be connected to the DATA 1 or DAT 2 output.
Output format available Number of external equipment
for data 1 and 2 that can be connected
NMEA0180 2 units each
NMEA0183Ver1.5 2 units each
NMEA0183Ver2.1 2 units each
JRC format 2 units each
NMEA0183Ver2.1/SEC 2 units each